 |
| |
|
|
| 802.11g 54/108Mbps Wireless LAN PCI Adapter |
| Introduction |
This 108M Wireless LAN PCI Adapter provides connectivity among desktop stations in a Wireless Local Area Network (WLAN).
It is compliant with IEEE 802.11g/b standard sharing the same 2.4GHz radio band and high-speed connection without any cabling.
By using Turbo mode ,this device offer data rate bandwidth up to 108M. It's an ideal device for SOHO and Home network to share high speed broadband conneciton. Files,printers sharing ...multimedia you need.
|
| Specification |
IEEE 802.11g Section |
| Standard |
2.4GHz OFDM (IEEE 802.11g) |
| Radioand Modulation Type |
BPSK, QPSK, 16QAM, 64QAM, OFDM |
| Operating Frequency |
2400 ~ 2483.5MHz ISM band |
| Channel Numbers |
11 channels for United States; 13 channels for Europe Countries ; 13 channels for Japan |
| Data Rate |
108, 54, 48, 36, 24, 18, 12, 9 and 6Mbp |
| Media Access Protocol |
CSMA/CA with ACK |
| Transmitter Output |
Typical RF Output Power at each Data Rate |
| Power |
+10 ~ 14dBm at 54Mbps
+11 ~ 15dBm at 48Mbps
+13 ~ 15dBm at 36Mbps
+17 ~ 18dBm at 24, 18, 12, 9, and 6Mbps |
| Receiver Sensitivity |
Typical Sensitivity at Which Frame (1000-byte PDUs) Error Rate = 10%
–87dBm at 6Mbps
–86dBm at 9Mbps
–85dBm at 12Mbps
–83dBm at 18Mbps
–80dBm at 24Mbps
–76dBm at 36Mbps
–71dBm at 48Mbps
–66dBm at 54Mbps
|
General Section |
| External Antenna |
Omni-directional dipole antenna with 2dBi |
| Internal Consumption |
Provides provision for an Internal Antenna attach (opton) |
| Form Factor and Interface |
PCI Local Bus 2.2 ComplianceLow-profile and half-length (PCI Raw Variable Height Short Card)PCI 32-bit Interface |
| Operating Voltage |
5VDC +/- 10% |
| LEDs |
POWER LED, NETWORK LED |
Information |
| General Information |
General Information shows the name of Wireless Adapter, Adapter MAC Address, Regulatory Domain, Firmware Version, and Utility Version. |
| Current Link Information |
Current Link Information shows the Current Setting ESSID, Channel Number, Associated BSSID, Network Type (infrastructure or Ad-hoc network), WEP Status (enable or disable), Link Status (Connect or Dis-connect), 802.11g Transmit Speed (6, 9, 12, 18, 24, 36, 48, 54, and 108Mbps), 802.11b Transmit Speed (1, 2, 5.5, 11Mbps), Signal Strength, and Link Quality. |
Configuration |
| ESS ID |
Input an SSID number if the roaming feature is enabledSupports for ASCII printable characters |
| Network Type |
Ad-hoc Mode and 802.11 Ad-hoc Mode for network configurations that do not have any access points
Infrastructure Mode for network configurations with access points |
| Power Save |
Extend the battery life of clients by allowing the client to sleep for short periods of time while the Access Point buffers the messages |
| Transmission Speed |
This indicates the communication rates. Select appropriate transmission speed to match your wireless LAN settings |
| Roaming |
Support Automatic or Manual Rescan to associate with access point |
Encryption |
| Encryption |
RC4 encryption algorithm
Supports 64-bit, 128-bit, and 152-bit WEP encryption
Support open system (OSA) and shared key authentication (SKA) |
Mechanical Requirements |
| Length * Width * Height |
6.6 inches *4.2 inches * 5.0mm |
|
※ Products and specifications are subject to the change without notice ※ |
 |
|
