 |
| |
|
|
| WLAN 54/108Mbps 802.11g Access Point |
| Introduction |
The INAP88GA is an IEEE 802.11g compliant wireless AP which brings the latest wireless technology and is backwards compatible with all the existing 802.11b products
The INAP88GA Wireless Access Point with turbo mode function boost performance up to 108Mbps , results in both data throughput and range coverage, is an ideal device to be deployed in SOHO and home environment.
The INAP88GA supports WDS bridging function which can connect two or more Access Points together at same time.
|
| Key Features |
- Fully Complies with IEEE 802.11b and 802.11g
- High-Speed Wireless Connection Up to 54 Mbps Data Rate
- Support 64/128/256 bits WEP (Wired Equivalent Privacy)
- Easy Installation, Management, and Configuration Reset
- Act as Repeater and AP at the Same Time via WDS
|
| Specification |
IEEE 802.11b Section |
| Standard |
IEEE 802.11b |
| Radio and Modulation Schemes |
DQPSK, DBPSK and CCK |
| Operating Frequency |
2400 ~ 2497MHz ISM band |
| Channel Numbers |
11 channels for United States
13 channels for Europe Countries
14 channels for Japan |
| Data Rate |
11, 5.5, 2, and 1Mbps |
| Media Access Protocol |
CSMA/CA with ACK |
| Transmitter Output Power |
Typical 18dBm at 11, 5.5, 2 and 1Mbps |
| Receiver Sensitivity |
Typical –83dBm for 11Mbps @ 8% PER(Packet Error Rate)
Typical –89dBm for 2Mbps @ 8% PER(Packet Error Rate) |
IEEE 802.11g Section |
| Standard |
IEEE 802.11g |
| Radio and Modulation Type |
BPSK, QPSK, 16QAM, 64QAM, OFDM |
| Operating Frequency |
2400 ~ 2483.5MHz ISM band |
| Channel Numbers |
11 channels for United States
13 channels for Europe Countries
14 channels for Japan |
| Data Rate |
108, 54, 48, 36, 24, 18, 12, 9 and 6Mbp |
| Media Access Protocol |
CSMA/CA with ACK |
| Transmitter Output Power |
Typical RF Output Power at each Data Rate+14 ~ 15dBm at 54Mbps and 108Mbps; +14 ~ 16dBm at 48Mbps; +16 ~ 18dBm at 36, 24, 18, 12, 9, and 6Mbps |
| Receiver Sensitivity |
Typical Sensitivity at Which Frame (1000-byte PDUs) Error Rate = 10%
–87dBm at 6Mbps; –86dBm at 9Mbps; –85dBm at 12Mbps; –83dBm at 18Mbps–80dBm at 24Mbps; –76dBm at 36Mbps;–71dBm at 48Mbps ; –66dBm at 54Mbps
General Section |
General Section |
| Interface |
Power Jack ; Factory Reset Button ; 10/100M Base-T (UTP) ;Wireless Dipole Antenna |
| Antenna Type |
Dipole antennas with 2dBi gain for 2.4GHz ;PIFA antennas with 2dBi gain for 2.4GHs -TBD |
| Ethernet Standard |
IEEE 802.3, IEEE 802.3u, IEEE 802.3x |
| Operating Voltage |
5VDC +/- 10% |
| Current Consumption |
MAX. 6W (TBD) |
| LEDs |
POWER LED ; 10/100M LED ;WIRELESS LED |
IEEE 802.11g Section |
| Wireless Band |
The Wireless Band of the AP can be viewed and set |
| Channel |
Can select the radio channel. The permissible channels dependent on the Wireless Band |
| Transmit Power Control |
Control TX power level from full, 50%, 25%, 12.5%, and min. |
| Radio control |
Radio on/off supported. |
| Auto Channel selection |
Scan channel and find a clear channel. |
| DFS/TPC |
Dynamic Frequency Selection and Transmit Power Control |
IEEE 802.11g Section |
| WEP Enable/Disable |
Enable or disable WEP for security function |
| Authentication Type |
Open System Authentication, Shared Key Authentication or both enabled |
| WEP Key Typ |
e WEP Key Format： Option for both Hex and ASCII |
IEEE 802.11g Section |
| Length * Width * Height |
110mm * 80 * 20mm |
|
※ Products and specifications are subject to the change without notice ※ |
 |
|
