INAP88GA

WLAN 54Mbps 802.11g Access Point
Features

¡EFully Complies with IEEE 802.11b and 802.11g

¡EHigh-Speed Wireless Connection Up to 54 Mbps Data Rate

¡ESupport 64/128/256 bits WEP (Wired Equivalent Privacy)

¡EEasy Installation, Management, and Configuration Reset

¡EAct as Repeater and AP at the Same Time via WDS
Specification

IEEE 802.11b Section
Standard IEEE 802.11b
Radio and Modulation Schemes DQPSK, DBPSK and CCK
Operating Frequency 2400 ~ 2497MHz ISM band
Channel Numbers 11 channels for United States
13 channels for Europe Countries
14 channels for Japan
Data Rate 11, 5.5, 2, and 1Mbps
Media Access Protocol CSMA/CA with ACK
Transmitter Output Power Typical 18dBm at 11, 5.5, 2 and 1Mbps
Receiver Sensitivity Typical ¡V83dBm for 11Mbps @ 8% PER(Packet Error Rate)
Typical ¡V89dBm for 2Mbps @ 8% PER(Packet Error Rate)

IEEE 802.11g Section
Standard IEEE 802.11g
Radio and Modulation Type BPSK, QPSK, 16QAM, 64QAM, OFDM
Operating Frequency 2400 ~ 2483.5MHz ISM band
Channel Numbers 11 channels for United States
13 channels for Europe Countries
14 channels for Japan
Data Rate 108, 54, 48, 36, 24, 18, 12, 9 and 6Mbp
Media Access Protocol CSMA/CA with ACK
Transmitter Output Power Typical RF Output Power at each Data Rate+14 ~ 15dBm at 54Mbps and 108Mbps; +14 ~ 16dBm at 48Mbps; +16 ~ 18dBm at 36, 24, 18, 12, 9, and 6Mbps
Receiver Sensitivity Typical Sensitivity at Which Frame (1000-byte PDUs) Error Rate = 10%
¡V87dBm at 6Mbps; ¡V86dBm at 9Mbps; ¡V85dBm at 12Mbps; ¡V83dBm at 18Mbps¡V80dBm at 24Mbps; ¡V76dBm at 36Mbps;¡V71dBm at 48Mbps ; ¡V66dBm at 54Mbps
General Section

General Section
Interface Power Jack ; Factory Reset Button ; 10/100M Base-T (UTP) ;Wireless Dipole Antenna
Antenna Type Dipole antennas with 2dBi gain for 2.4GHz ;PIFA antennas with 2dBi gain for 2.4GHs -TBD
Ethernet Standard IEEE 802.3, IEEE 802.3u, IEEE 802.3x
Operating Voltage 5VDC +/- 10%
Current Consumption MAX. 6W (TBD)
LEDs POWER LED ; 10/100M LED ;WIRELESS LED

Wireless Setting
Wireless Band The Wireless Band of the AP can be viewed and set
Channel Can select the radio channel. The permissible channels dependent on the Wireless Band
Transmit Power Control Control TX power level from full, 50%, 25%, 12.5%, and min.
Radio control Radio on/off supported.
Auto Channel selection Scan channel and find a clear channel.
DFS/TPC Dynamic Frequency Selection and Transmit Power Control

Security Setting
WEP Enable/Disable Enable or disable WEP for security function
Authentication Type Open System Authentication, Shared Key Authentication or both enabled
WEP Key Typ e WEP Key Format: Option for both Hex and ASCII

Mechanical Requirements
Length * Width * Height 110mm * 80 * 20mm

Copyright (c) 2004 INFOSMART Technology Co.,Ltd. All right reserved. sales@infosmart.com.tw